SMPS LED Lighting Device

Electricical Specification

General Specification

• Electrical Safety Approval : KC, EMC, EMS
• LED Lighting Device
• Waterproof Protective Grade : IP68
• Protective Function - Short Circuit, Overload, Over-Voltage, Over-Temperature
• External control(of voltage, current) enabled to suit the characteristics of LED
• Utility Patent and Circuit Patent Pending
• AC Input, Over-Voltage Protection (Over 270Vac: Power shut off / Under 260Vac Auto-Recovery)

PFC Introduction

PFC is the initial of Power Factor Correction that means a correction in the power-efficiency. To be simple, electric power saving circuitry is added to power supply to raise the power-efficiency. For example, it controls the electric power going into components such like ballast stabilizer or light transformer which is occurred momentary leaking of power.
PFC adjusts the voltage going into component part by itself to supply stabilized electric power to the other parts.

Advantage of PFC

1. Supply more stabilized current to each of components
2. Reduction the waste of electric power consumption
3. Prevent a rise in temperature caused by the heat converted from the unnecessary current
4. Lower the level of noise caused by the reduced fan speed
5. Reduction electromagnetic waves

Caution

This product is LED convertor for only LED lamp.

1. SMPS should ideally be operated within 70% of it's normal capacity.
2. Install in a well ventilated area away from direct sun light. Over temperature protection)
3. If two or more units are to be installed, keep a distance of at least 30cm between the units to be installed.
4. The earth wire must be connected to the ground. (Otherwise, It's not guaranteed.)
5. Please check input voltage and follow connection diagram before use.
6. Damages caused by natural disaster including lightening and surge are not covered under the warranty.